Auto Specialties recommends that these pulleys be installed by a qualified mechanic.

1. REMOVE UPPER FAN SHROUD/WATER BOTTLE BY REMOVING 2 BOLTS, ONE EACH SIDE. UNPLUG THE 2 SENSORS ON PASSENGER SIDE PLUG DRAIN HOSE. LIFT OUT.

2. REMOVE FAN, NUT IS STANDARD THREAD.

3. REMOVE ELECTRIC FAN. UNPLUG FROM BOTTOM. IF USING NEW ALTERNATOR PULLEY, LOOSEN NUT AT THIS TIME WITH IMPACT. REMOVE PULLEY WHEN BELT IS REMOVED.

4. REMOVE BELT.

5. USE IMPACT WRENCH TO REMOVE CENTER BOLT. USE A 3 JAW PULLER TO REMOVE STOCK BALANCER.

6. REPLACE WITH NEW ASP BALANCER. DO NOT BOLT ON PULLEY AT THIS TIME.

7. PLACE GREASE AROUND OUTSIDE OF BALANCER HUB AND RTV SEALANT INSIDE KEY WAY.

8. ON BOLT PLACE GREASE UNDER WASHER. TIGHTEN UNDER LOW AIR PRESSURE UNTIL IT STOPS. TIGHTEN TO 80 FT/LBS.

9. USE LOSTITE ON 3/8 BOLTS TO INSTALL NEW INSTALL.

10. INSTALL NEW GATES BELT K060854 WITH INSTALLATION OF CRANK ONLY #501150. INSTALL NEW GATES BELT K060858 WITH INSTALLATION OF CRANK AND ALTERNATOR #501151.

11. REVERSE ORDER TO REPLACE REMOVED PARTS.
ALL ASP BALANCERS ARE WARRANTED FOR ONE YEAR FROM PURCHASE.