BBK Long Tube Headers for your 1996-2004 Mustang GT

BBK Long Tube Headers


for your 1996-2004 Mustang GT


BBK Long Tube Headers
Fits 1996-2004
GT Mustang
  • 1 5/8″ primary tubes
  • 3/8″ Thick laser-cut flanges
  • 20+ HP
  • Includes All Installation Hardware
  • For Racing Use Only
  • Racing Verification
Click Tech Button for Install Sheet

If you want to transform your 2V Mustang into a racing machine, one area you must focus on is your exhaust, specifically your headers and mid-pipe. These BBK full length headers for the 1996-2004 GT are ceramic coated to keep the heat from your exhaust down and will give you up to 20 HP at the wheels with these headers and a corresponding flanged-end shorty x-pipe.


Each set is built from computer mandrel-bent 1 5/8″ tubing, and have 3/8″ thick laser-cut flanges delivering un-matched quality at prices that won′t destroy your bank account.


Note: These 1-5/8″ BBK full length GT Headers are a direct bolt on when used with the BBK long-tube x-pipe, either off road BBK 1635 or with catalytic converters BBK 1638. They will bolt directly up to factory or after market cat-back system but will require significant modification to achieve. These headers are designed for mustangs with manual transmissions.


What size headers do I need? Click Here

NOTICE: This product is ONLY for sale to individuals who confirm they are not installing these items on any Motor Vehicle in the U.S.A. . By purchasing any product labelled as such, customer confirms they abide by all rules concerning state and local emissions laws including the federally mandated Clean Air Act. It is NOT legal for sale or use on any pollution controlled Motor Vehicle in any U.S State regardless of Local / State emissions enforcement. Legal only for Racing / Prototype / Display / or any other type of vehicle that has been determined by the EPA (Environmental Protection Agency) to be incapable of safe or practical street or highway use. due to but not limited to;

1. It lacks features associated with safe and practical street or highway use, such features including, but not limited to, a reverse gear (except in the case of motorcycles); that cannot be installed economically relative to the value of the vehicle or;

2. It exhibits features which are not readily removed, which render its use on streets and highways unsafe or impractical; a differential, or substantial safety features required by state and/or federal Law.

For more information on exemption requirements please click on this Clean Air Act Info. It is the buyers responsibility to meet these exemption requirements BEFORE removing ANY Emissions equipment or purchasing any device listed on this site listed as "Race Only"