METCO Supercharger Pulley Puller for your Ford Supercharged Vehicle

METCO Supercharger Pulley Puller


for your Ford Supercharged Vehicle


METCO Supercharger Pulley Puller


Vehicle:
1999-2004 Lightning / Harley
2003-2004 SVT Cobra



This custom installation tool greatly simplifies the process of installing any high-boost supercharger pulley on your Supercharged vehicle.


METCO Removal / Install tool works on all Ford Lightning, Harley Trucks, 03 Cobra, Xterra supercharged, and is required for pulley installation on same applications.

Pulley Removal "HOW TO"

Step 1 Pulley Removal

Step 1: Remove bolt or plastic screw cap in center of factory blower pulley.

Step 2 Pulley Removal

Step 2: Important: Grease must be applied to threads to prevent galling.



Step 3 Pulley Removal

Step 3: Install the provide 5/16 washer on bolt stud. Screw the 5/8 shaft onto the blower snout 100%.

Step 4 Pulley Removal

Step 4: Tighten the two allen head 3/16 bolts (step 5.) evenly to horse shoe to ensure correct distribution of tension to pulley plate. Make sure gold nut is installed between pulley and removal square bar.


Step 5 Pulley Removal

Step 5: Important: Both bolts must be evenly threaded in order to pull off without damage to the shaft.

Step 6 Pulley Removal

Step 6: Turn counter clockwise to apply pressure to nut closet to pulley. Use a second wrench to keep outer welded nut from turning.


Load up puller until pulley pops. This will allow tight removal from shaft. The pulley will be tight during the ENTIRE removal.

Pulley Install "HOW TO"

Step 1 Pulley Install

Step 1: Installation requires only the 5/8 bolt, square steel brace, 5/8 washer and nut.

Step 2 Pulley Install

Step 2: Tighten the two allen head 3/16 bolts (step 5.) evenly to horse shoe to ensure correct distribution of tension to pulley plate. Make sure gold nut is installed between pulley and removal square bar.


Step 3 Pulley Install

Step 3: Press on new pulley. It will be a tight fit all the way on. Pulley will be installed correctly when pulley is flush with blower shaft.


During install, the welded end of the install shaft must not turn. If it turns you will break off the pilot screw in the blower shaft. Two 15/16 wrenches are required to prevent the tighten or loosening of the install shaft.

Step 4 Pulley Install

Step 4: Check the pulley to make sure it is flush with the shaft.